from test.test_support import verify, TESTFN import sys, os import gzip filename = TESTFN data1 = """ int length=DEFAULTALLOC, err = Z_OK; PyObject *RetVal; int flushmode = Z_FINISH; unsigned long start_total_out; """ data2 = """/* zlibmodule.c -- gzip-compatible data compression */ /* See http://www.gzip.org/zlib/ /* See http://www.winimage.com/zLibDll for Windows */ """ f = gzip.GzipFile(filename, 'wb') ; f.write(data1 * 50) # Try flush and fileno. f.flush() f.fileno() if hasattr(os, 'fsync'): os.fsync(f.fileno()) f.close() # Try reading. f = gzip.GzipFile(filename, 'r') ; d = f.read() ; f.close() verify(d == data1*50) # Append to the previous file f = gzip.GzipFile(filename, 'ab') ; f.write(data2 * 15) ; f.close() f = gzip.GzipFile(filename, 'rb') ; d = f.read() ; f.close() verify(d == (data1*50) + (data2*15)) # Try .readline() with varying line lengths f = gzip.GzipFile(filename, 'rb') line_length = 0 while 1: L = f.readline(line_length) if L == "" and line_length != 0: break verify(len(L) <= line_length) line_length = (line_length + 1) % 50 f.close() # Try .readlines() f = gzip.GzipFile(filename, 'rb') L = f.readlines() f.close() f = gzip.GzipFile(filename, 'rb') while 1: L = f.readlines(150) if L == []: break f.close() # Try seek, read test f = gzip.GzipFile(filename) while 1: oldpos = f.tell() line1 = f.readline() if not line1: break newpos = f.tell() f.seek(oldpos) # negative seek if len(line1)>10: amount = 10 else: amount = len(line1) line2 = f.read(amount) verify(line1[:amount] == line2) f.seek(newpos) # positive seek f.close() # Try seek, write test f = gzip.GzipFile(filename, 'w') for pos in range(0, 256, 16): f.seek(pos) f.write('GZ\n') f.close() f = gzip.GzipFile(filename, 'r') verify(f.myfileobj.mode == 'rb') f.close() os.unlink(filename)