diff options
Diffstat (limited to 'doc/fconfigure.n')
| -rw-r--r-- | doc/fconfigure.n | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/doc/fconfigure.n b/doc/fconfigure.n index 38799b5..da52671 100644 --- a/doc/fconfigure.n +++ b/doc/fconfigure.n @@ -4,7 +4,7 @@ '\" See the file "license.terms" for information on usage and redistribution '\" of this file, and for a DISCLAIMER OF ALL WARRANTIES. '\" -'\" RCS: @(#) $Id: fconfigure.n,v 1.6 2001/10/15 17:35:05 hobbs Exp $ +'\" RCS: @(#) $Id: fconfigure.n,v 1.7 2002/07/01 18:24:39 jenglish Exp $ '\" .so man.macros .TH fconfigure n 8.3 Tcl "Tcl Built-In Commands" @@ -66,7 +66,7 @@ automatically after every output operation. The default is for \fB\-buffering\fR to be set to \fBfull\fR except for channels that connect to terminal-like devices; for these channels the initial setting is \fBline\fR. Additionally, \fBstdin\fR and \fBstdout\fR are -intially set to \fBline\fR, and \fBstderr\fR is set to \fBnone\fR. +initially set to \fBline\fR, and \fBstderr\fR is set to \fBnone\fR. .TP \fB\-buffersize\fR \fInewSize\fR . @@ -231,7 +231,7 @@ system. The \fItype\fR parameter is case-independent. If \fItype\fR is \fBnone\fR then any handshake is switched off. \fBrtscts\fR activates hardware handshake. Hardware handshake signals -are decribed below. +are described below. For software handshake \fBxonxoff\fR the handshake characters can be redefined with \fB-xchar\fR. An additional hardware handshake \fBdtrdsr\fR is available only under Windows. @@ -251,7 +251,7 @@ of bytes in the input and output queue respectively. . (Windows and Unix). This option is used to set the timeout for blocking read operations. It specifies the maximum interval between the -receiption of two bytes in milliseconds. +reception of two bytes in milliseconds. For Unix systems the granularity is 100 milliseconds. The \fB-timeout\fR option does not affect write operations or nonblocking reads. @@ -357,9 +357,9 @@ a "Carrier" signal. A BREAK condition is not a hardware signal line, but a logical zero on the TXD or RXD lines for a long period of time, usually 250 to 500 milliseconds. Normally a receive or transmit data signal stays at the mark -(on=1) voltage until the next character is tranferred. A BREAK is sometimes +(on=1) voltage until the next character is transferred. A BREAK is sometimes used to reset the communications line or change the operating mode of -cummunications hardware. +communications hardware. .RE .SH "ERROR CODES (Windows only)" |